Petes Castles
Bouncy Castle Hire
ANY SECOND ITEM FREE
IS NOW AVAILABLE DURING 2010
WEEKDAYS AND WEEKENDS !!!!
LOWEST PRICES FOR 2010
LOWEST PRICES FOR 2010SPECIAL OFFER
LONG TERM HIRE IS AVAILBLEWelcome To Petes Castles
SETTING UP CASTLES AND SLIDES
1. First locate the smoothest most level place in the garden or the area where it is to be set up. If it is going on a rough, dry, oily, dirty, abrasive piece of land or concrete a groundsheet must be placed under the unit. The same goes for land.
2. To prevent any possible damage to the Bouncy Castle, always walkover the area first to check and remove any large stones, sticks or other items you may find.
3. Unroll and unfold, position as required, spread out each side as much as they will.
4. Connect the blower to the long tube (inlet tube) usually at the back of the Bouncy castle and secure tightly with rope.
5. tie any other deflation tubes with rope or do up if there are zips, which will be at the back or the side of the Bouncy Castle.
6. Fully unroll extension cable (to prevent the cable from overheating)
7. Plug blower cable into extension socket. Switch on blower and allow Bouncy castle to inflate. It takes approx 2 minutes to inflate. Please ensure there are no Children on the castle whilst it inflates. The blower MUST remain running continuously whilst the castle is in use.
8. If used outdoors the unit must be anchored using the anchor points located around the base. Stake castle down by inserting anchor stakes through anchor ropes placed through the anchor point loops on Bouncy Castle sides. Please ensure the stakes are well into the ground so as not to create a hazard to Children.
9. If used on a hard surface or indoors safety mats should be placed in front of the unit.
10. Electrical cables should be laid along the edge of the garden, out of Children's way. They should also be fully protected from damage of water
PACK AWAY CASTLES AND SLIDES
1. Make sure the Bouncy Castle/Slide is completely empty of all children and any debris and is in a clean dry condition. ( If wet please inflate and dry with a towel first)
2.Switch off the electric supply, disconnect the blower and wrap power cord neatly around funnel.
3. Untie any other air way tubes or undo any airway zips which will be at the side or back.
4.Allow the inflatable to completely deflate (Walking or rolling on the castle, will speed up deflation, kids love to volunteer for this job!).
5. Straighten the base and fold the walls neatly inwards, then fold in half and half again the same way.
6 When you have a strip the width or smaller than the height of the storage bag, start rolling slowly and tightly towards the air vent, kneel or stand on each roll .
